Bio-rad S3™ Cell Sorter Manual de usuario descargar pdf (Pagina 31)

Instruction Manual | 21

Troubleshooting

Table 7 describes possible errors and causes with troubleshooting steps.

Table 7. Troubleshooting table.

Error Possible Causes Troubleshooting Steps

Biosafety system icon System not conﬁgured to have Contact technical support to correct the

does not show up in a biosafety system conﬁguration of the system

ProSort

™

software

There is no fan noise System is very quiet Stand closer to fan unit and listen for fan

coming from the unit noise. There should be a quiet hum

Not plugged in correctly Check AC power cord for a tight connection

on system and in the wall

HEPA may be full and system Check the biosafety system status in ProSort

has shut down. software to see if the system’s HEPA is at

less than 10% capacity. HEPA ﬁlter may need

replacement

There is a rattling noise Loose ﬁtting or latch Check all connections and latches. The

coming from the air system should have a quiet hum and low

generator fan unit vibration

There is a large gap Misaligned magnetic attachment Re-attach the access door. Adjust by gently

between magnetic bending the access door to eliminate the

connections on gap. If the gap remains and the access door

access door border matches with the panel borders, then

system is functional

The panels do not stay Panels do not lie well against air Roll the panels slightly tighter so they can lie

up when opened generator and plastic top panel evenly on the plastic top panel

The access doors are S3 or S3e cell sorter is in the Adjust the S3 or S3e cell sorter carefully to

not aligned with the improper location line up with the access doors as much as

system components Improper location may not maintain safety

1 2 ... 26 27 28 29 30 31 32 33 34 35 36

Sin comentarios

Bio-rad S3™ Cell Sorter Manual de usuario Pagina 31