Bio-rad BioLogic LP System Manual de usuario Pagina 15

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 106
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 14
8
Description of Components
Table 3. (continued)
BioLogic LP Controllers Rear Panel Connectors
Connector Description
Fraction Collector: The BioLogic LP supports the Bio-Rad Model 2110 and Model
2128 fraction collectors, as well as other fraction collectors. This port sends
“Advance” signals to the fraction collector.
Instrument bus (phone jack connector): This connector is reserved for internal Bio-
Rad use.
Test Port: This connector is reserved for internal Bio-Rad use.
Aux connector: This connector is reserved for internal Bio-Rad use.
UV Lamp: This specialized 6-pin square port provides electrical power to the mercury
lamp in the UV Optics module’s lamp housing.
12 Volt: This is a 12 V DC power source designed to power optional equipment.
Power Connectors: There are two power connectors. They are keyed so that you
can plug a fraction collector into one power connector and the BioLogic LP
Controller’s power cord into a power strip. This arrangement means the fraction col-
lector’s power switch can be left in the ON position. The BioLogic LP Controller’s
power ON/OFF switch then turns on/off both the BioLogic LP Controller and the frac-
tion collector.
Vista de pagina 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 105 106

Comentarios a estos manuales

Sin comentarios