installation and Operation of
LP
Data View software for the
BioLogic
LP
System
Note: Due to the ease of use of the LP Data View software, a conventional hard copy instruction manual is not included.
This Installation and Operation guide will enable you to install
LP
Data View on your computer and to become familiar
with its operation. See the on-line HELP function of
LP
Data View for additional information about features of this
program.
Computer Requirements.
PC with one available serial port and with Windows
95
or Windows NT version
4.0
operating systems.
Section I installation
1.
Ensure that both the BioLogic LP system and the computer are turned off.
2.
Connect the serial cable (supplied with the software) from the
COMM
port on the rear of the Biologic LP System to either
COM
1,
COM
2 or
COM
3 on the computer. You may need to use the supplied port adapter.
Note that
25
feet is the maximum
serial’cable
length supported by the
BioLogic
LP
system and
LP
Data View at this time.
3.
Turn on the computer and install the LP Data View software as follows.
i.
For both Windows
95
and NT users, insert diskette number
1.
ii.
Go to Start, Settings, Control Panel, Add/Remove Programs and follow the screen prompts to install
LP
Data
.
View.
4.
Turn on the BioLogic LP System and then launch the
LP
Data View application from the computer.
5.
Data View uses
COM
2 as the default port.
If another
COM
port is used, you will see a dialog box reading:
6.
Click on
Setup.
Another dialog box will ask you to select the correct
COM
port. Make your selection and click
OK.
7.
You should now see the main
Chromatogram
Run screen with the
Receive
indicator light green.
8.
Congratulations! You are now ready to record your data.
Sections
2,
and 3 will provide a brief explanation of how to use Data View. A, more comprehensive explanation can be
found by selecting the on-screen
HELP
function.
.
Section
2.
Using Data View as an electronic chart recorder
To Monitor
Pre-Run
Column Equilibration Steps
1.
Click on
Record.
LP Data View will act just like a chart recorder and record
UV
and conductivity data from the
BioLogic
LP
System. You may scale the axes at any time. To stop recording, click on
Stop.
2.
To clear the screen, click on
Clear.
Recording Method Steps
1.
If
you
wish to view and print the Method before it is run, use the following procedure.
i.
Close any Run you are viewing and use the
Clear
button or
Chart Recorder
tab to obtain a blank chart recorder
screen.
ii.
Click on
the Record
button.
(4 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales