Bio-rad Model 2110 Fraction Collector Manual de usuario descargar pdf (Pagina 13)

Section 5

Instrument Set-Up

5.1 Tubing Installation

1. Insert the drop former, narrow end downward, into the drop arm,

pressing it firmly in the hole (see Figure 4.1).

2. Using a twisting motion, press the arm cap onto the drop arm to hold

the drop former in place.

3. Insure that the end of the inlet tubing is cleanly cut and not flattened

or deformed.

Insert tubing into the drop former, pushing down on the tubing until

the drop former starts to stretch. Do not use excessive force. Then,

gently pull out on the tubing until the drop former returns to its

original shape.

4. The inlet tubing may be routed through the tubing holder fitting at the

rear of the movable portion of the drop arm.

M7318120G.qxd 10/21/2002 2:48 PM Page 9

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 28 29

Sin comentarios

Bio-rad Model 2110 Fraction Collector Manual de usuario Pagina 13